Making studio recordings sound exciting and powerful is a real skill. The loudness of your guitar amplifiers and the power of your drummer are not enough to make the recordings of your songs express the actual loudness and power of the real performance.
Working with Logic Studio, I have found out a number of methods (that are partly inspired by the tricks used in professional mixes I found impressive) to make recordings sound more powerful.
The journey starts when you prepare your recordings. There are many general things that can make a lot of difference in the end result. For instance I highly recommend you to warm up your voice before starting vocal recordings. This 3d audio sounds trivial, but it is the key to a powerful and uninhibited vocal performance. The next point I personally pay close attention to is the position of microphones. You should position microphones close enough to the sound source you want to record in order to avoid significant background noise or sound reflected by the walls of the room. But I highly recommend you to position microphones (if possible) at a distance of at least 30 centimeters (one foot) to the instrument you are recording. I know this is quite the opposite of what is usually done in studios (especially with drums), but I have good reason to make this recommendation. The problem with having microphones to close to the source of sound is a very unauthentic sound on the recording. Think about it -- the bass drum does not sound the same if you lean your head against it. In my opinion it is terribly difficult to restore the original sound (as you experience it from a usual distance) afterwards -- especially without any reference.
Once you have done your recordings, there are different options you should consider for the editing. One of the basic (yet most powerful) tools included in practically every audio editing software is the equalizer -- if you are using Logic, I recommend to stay with the easy to use, yet comprehensive "Channel EQ" plug-in. To make your mix appear clear to your listeners, one fundamental approach is to assign a 'role' to each instrument (or sound) in your arrangement. Decide for each element whether it should stand out, or play a supportive role. Accordingly, you might raise or lower the levels of certain frequencies, which is when the actual sound design begins. The single elements should not sound complete individually, but all of them together should. To make all elements clearly audible, it does not help to add treble frequencies to all of them, nor to raise them all to the same volume level. It is important to leave 'gaps' in the mix (mostly by avoiding the extensive use of certain frequencies 'needed' for other instruments) to embed further elements -- there should be no competition among the instruments in your mix. Instead, they should seem to complete each other. Yet you should try not to disfigure the typical sound of the instruments -- it takes some experience to really get used to that balancing act, but after some time you will easily find out what frequencies are typical of an instrument, and which can be neglected with one particular instrument, so they are 'available' for other instruments that 'need' them to maintain their typical sound.
Having explained these basics, I would like to focus on adding the powerful nuance to the sound of your recordings. The drums play a relatively important role in rock music generally. Making them sound powerful is crucial to get the right sound. Basically, drums profit from treble and bass frequencies, and usually should not contain too much of mid-range frequencies if they are supposed to sound powerful. The only exception are toms -- they can sound more mighty with some well-chosen mid-range frequencies. This applies especially to floor toms -- to make them sound more full, adding low mid-range or bass frequencies can have a surprisingly positive effect.
The snare drum can also contain additional mid-range frequencies, but usually tends to sound rather peculiar if too much of these are added. Depending on the raw material, I personally add three dB around 400 Hz to bring out the characteristic sound of the snare drum, I also tend to reduce or even cut all bass and low mid-range frequencies (up to 200 Hz) of snare drums to make them sound more tight.
No comments:
Post a Comment